416
Exiting edit mode automatically when a
register is recalled during editing
You can configure a setting such that edit mode ends
when a register is recalled during effect timeline edit
mode.
1
Open the Home > Setup > Panel > Custom > Effect
TL/Macro Mode menu (19104.63).
2
Press the [Edit Enable Auto Off] button.
On: Exit e
ffect timeline edit mode.
Off:
Continue in effect timeline edit mode.
Setting the operation of the first keyframe
when a register is recalled
1
Open the Home > Setup > Panel > Custom > Effect
TL/Macro Mode menu (19104.63).
2
In the [Recall Mode] group, select an action for the
first keyframe.
Recall: Do not
execute the first keyframe when a
register is recalled.
Recall&Rewind:
Execute the first keyframe when a
register is recalled.
Setting the operation when the [RUN]
button is pressed during effect timeline
execution
You can set the operation when the [RUN] button in the
utility/shotbox control block and utility control block or
the [Run] button in the menu is pressed again while
executing an effect timeline.
1
Open the Home > Setup > Panel > Custom > Effect
TL/Macro Mode menu (19104.63).
2
In the [Run 2nd Press Mode] group, select an
operation mode.
Continue:
Continue execution of the effect timeline.
Cancel: C
ancel the effect timeline and return to the
previous state.
Setting the operation of the first keyframe
when rewind is executed
You can set execution of the first keyframe when rewind
is executed on a GPI, P-Bus, DDR/VTR, and macro effect
timeline.
When enabled, the first keyframe is not execute
d when an
effect timeline is executed by pressing the [RUN] button
in the utility/shotbox control block and utility control
block or the [Run] button in the menu.
1
Open the Home > Setup > Panel > Custom > Effect
TL/Macro Mode menu (19104.63).
2
In the [Rewind&1st KF] group, set the button for the
target effect timeline to the on state.
GPI: GPI ti
meline
P-Bus: P-Bus ti
meline
DDR/VTR: DDR/
VTR timeline
Macro: M
acro timeline
To disable the setting
In the [Rewind&1st KF] group
, set the button for the
target effect timeline to the off state.
Setting the Macro Mode
Setting the macro execution mode
1
Open the Home > Setup > Panel > Custom > Effect
TL/Macro Mode menu (19104.63).
2
In the [Macro Execution Mode] group, select a macro
execution mode.
Normal: Normal
execution mode
Step: Step e
xecution mode
To enable simultaneous execution of
multiple macros
You can enable macro multi mode.
1
Open the Home > Setup > Panel > Custom > Effect
TL/Macro Mode menu (19104.63).
2
Set the [Macro Multi Recall Mode] button to the on
state.
To disable multi mode
Set the [Macro Multi Recall Mode] button to the off state.
Setting the operation when a different
macro is recalled during macro execution/
pause
1
Open the Home > Setup > Panel > Custom > Effect
TL/Macro Mode menu (19104.63).
Note
To Next Page
Loading...
