Sony XVS-G1 - Configuring SNMP

454
Displaying a group
You can check information about groups in the System
Configuration > User Account > Manage Groups menu
(20601.21).
Current User: Name of the
currently signed-in user
Group Name: Names of the registered groups
No. of Users: Number of users belonging to a group
Creating a group
You can create up to 15 groups, not counting the default
groups.
1 Open the System Configuration > User Account >
Manage Groups menu (20601.21).
2 Press the [Add Group] button.
The [Add Group] window appears.
3 Press the [Input Group Name] button and enter a
group name (up to 32 characters) using the keyboard.
The valid characters for group names are single-byte
al
phanumeric characters and periods.
4 Press [OK].
Deleting a group
1 Open the System Configuration > User Account >
Manage Groups menu (20601.21).
2 Select the target group to delete.
3 Press the [Delete Group] button.
4 Check the message, then press [OK].
Renaming a group
1 Open the System Configuration > User Account >
Manage Groups menu (20601.21).
2 Select the target group to rename.
3 Press the [Edit Group Name] button.
The [Edit Group Name] window appears.
4 Press the [Input Group Name] button and enter a
group name (up to 32 characters) using the keyboard.
The valid characters for group names are single-byte
al
phanumeric characters and periods.
5 Press [OK].
Configuring SNMP
Enabling/Disabling SNMP
1 Open the System Configuration > SNMP > Common
menu (20701.11).
2 Enable/disable SNMP using the [Enable] button for
[SNMP Mode].
On: Enable
SNMP.
Off: Disable
SNMP.
When disabled, proceed to step 4.
3 Set whether to send a trap when authentication fails
using the [Auth Trap] button.
On: Send t
rap when SNMP authentication fails.
Off: Do not
send trap when SNMP authentication
fails.
4 Press the [Apply] button.
To return to the previous setting
Press the [Clear] button, check t
he message, then
press [OK].
5 Check the message, then press [OK].
Configuring an MIB Object
You can configure management information for SNMP.
1 Open the System Configuration > SNMP > Common
menu (20701.11).
2 Press the [System Name] button for [MIB-2 System
Variables] and enter a system name using the
keyboard.
The system name setting is linked to the host name
sett
ing in the System Configuration > Network >
Network Settings menu (20201.11).
3 Press the [System Contact] button for [MIB-2 System
Variables] and enter the administrator information
(up to 255 characters) using the keyboard.
4 Press the [System Location] button for [MIB-2
System Variables] and enter the system location
information (up to 255 characters) using the
keyboard.
Note