Sony XVS-G1

337
Copying Files
You can copy files in each category between packages.
Files cannot be copied t
o a locked package.
1 Open the Home > File > All > Copy > Copy menu
(10102.21).
2 Press the [Select] button in the [Source Package]
group.
The [Select Package] wind
ow appears.
3 Select a copy source package and press [OK].
To select the default package
Press the [Default Package] butt
on.
If there is no default package, a new default package
i
s created.
4 Press the [Select] button in the [Target Package]
group.
The [Select Package] wind
ow appears.
5 Select a copy destination package and press [OK].
To create a new package
Press the [New Package] button to display the [New
Pa
ckage] window.
Specify a package name, tags, and memo in
the same
way as in [Edit Properties] window.
For details, see “Editing Package Properties”
(page 334).
To select the default package
Press the [Default Package] butt
on.
If there is no default package, a new default package
i
s created.
6 Select the target category to copy.
To select a setup data category,
select a button in the
[Setup] group.
To select a register data category, select a button in
t
he [Register] group.
To select all categories, set the [All Categories]
bu
tton to the on state.
The categories saved in the se
lected copy source and
copy destination packages are displayed in white
characters in the [Source Package] group/[Target
Package] group category display area.
The files in the categories inc
luded in the copy source
package become the target for copying.
If the copy destination package
already contains the
same categories, the files will be overwritten.
7 Press the [Copy] button.
8 Check the message, then press [OK].
The files in the selected ca
tegories are copied.
Note
Note