Sony XVS-G1

393
Setting the Cross-Point Hold
Operation Mode
You can set the cross-point hold operation mode on a key
bus.
The cross-point hold operation
mode is also applied to
snapshot attributes.
1 Open the Home > Setup > Switcher > Custom > Key/
Wipe menu (19103.43).
2 Select the target switcher bank to set.
3 Press the [Xpt Hold Mode] button and select a cross-
point hold operation mode from the pull-down list.
Key Disable: Th
e cross-point hold button of the key
bus functions as a key disable set button.
When the cross-point hold butt
on is enabled, the
cross-point selection information and the key
settings information are not applied, even when a
snapshot or effect timeline is recalled.
Key Dsbl with Status: Same
as [Key Disable], but
also does not reflect the key on/off status.
Xpt Hold:
The cross-point hold button of the key bus
functions as a cross-point hold set button.
When the cross-point hold butt
on is enabled, the
cross-point selection information is not applied,
even when a snapshot or effect timeline is
recalled.
Setting the Operation Mode When
the Pattern Limit is Released
1 Open the Home > Setup > Switcher > Custom > Key/
Wipe menu (19103.43).
2 Select the target switcher bank to set.
3 Press the [Pattern Limit Transition] button and select
an operation mode for when a pattern limit is released
from the pull-down list.
Auto: Whe
n the pattern limit is released, the
remainder of the transition is executed
automatically at a dedicated transition rate.
Manual: Aft
er the pattern limit is released, the
transition waits for the next operation, then
executes. The transition is not executed until you
operate the fader lever or press the [AUTO
TRANS] button.
Setting the Default Wipe Edge
Softness
1 Open the Home > Setup > Switcher > Custom > Key/
Wipe menu (19103.43).
2 Select the target switcher bank to set.
3 Press the [Wipe Edge Default] button and set the
following parameter.
Enabling/Disabling Video Process
Memory
1 Open the Home > Setup > Switcher > Custom > Key/
Wipe menu (19103.43).
2 Enable/disable using the [Video Proc Memory]
button.
On: En
able the video process memory.
Off: Disab
le the video process memory.
Setting Show Key
1 Open the Home > Setup > Switcher > Custom > Key/
Wipe menu (19103.43).
2 You can enable/disable show key for each preview
output in the [Show Key Enable] group.
M/E-1 PVW: M
/E-1 preview output
M/E-2 PVW: M
/E-2 preview output
M/E-3 PVW: M
/E-3 preview output
M/E-4 PVW: M
/E-4 preview output
M/E-5 PVW: M
/E-5 preview output
P/P PVW: P/P pr
eview output
EDIT PVW: Ed
it preview output
Set the buttons for the previ
ew outputs to enable to
the on state.
3 Press the [Show Key Hold Time] button and enter a
show key hold time (frames) in the numeric keypad
window.
No. Parameter Adjustment
1 Soft Default value of wipe edge
softness