429
2
Select the target external box to set.
Select [Ext Box 1] to [Ext Box 5] for [Device].
3
Press the [Matrix Size] button and select a size from
the pull-down list.
- - -: Do
not use.
4×1:
4 inputs, 1 output
8×1:
8 inputs, 1 output
16×1: 16
inputs, 1 output
The maximum number of inputs for all external boxes
is 1
8.
4
Press the [Source] button and enter an address for the
first source in the numeric keypad window.
5
Press the [Destination] button and enter an address
for the first destination in the numeric keypad
window.
6
Press the [Level] button and enter a level (1 to 8) in
the numeric keypad window.
Coupling external boxes
You can increase the number of inputs by coupling
external boxes.
Setting the same destination and level for multiple
external boxes
couples the external boxes.
This section describes the coupling of external box 1 (4
inputs) and
external box 2 (8 inputs) as an example.
1
Open the Home > Setup > Router/Tally > NS-Bus >
Matrix menu (19106.11).
2
Select [Ext Box 1] for [Device] and configure
external box 1.
Press the [Matrix Size] button
and select [4×1] from
the pull-down list.
Press the [Source] button and enter an address for the
first
source in the numeric keypad window.
Press the [Destination] button and
enter an address
for the first destination in the numeric keypad
window.
Press the [Level] button and ent
er a level (1 to 8) in
the numeric keypad window.
3
Select [Ext Box 2] for [Device] and configure
external box 2.
Press the [Matrix Size] button
and select [8×1] from
the pull-down list.
Press the [Source] button and enter an address for the
first
source in the numeric keypad window.
Press the [Destination] button and enter t
he same first
address as for external box 1 in the numeric keypad
window.
Press the [Level] button and set the same level as for
ex
ternal box 1 in the numeric keypad window.
External boxes 1 and 2 become coupled and can be
u
sed as an external box with 12 inputs (4 + 8).
Selecting an Alias Name Group
You can select an NS-Bus alias name group.
1
Open the Home > Setup > Router/Tally > NS-Bus >
Matrix menu (19106.11).
2
Press the [Alias Name Group No.] button and select a
group number (1 to 8) from the pull-down list.
Note
To Next Page
Loading...
