Sony XVS-G1

448
To set an interface other than standard interface
1 (STD 1)
1 Open the System Configuration > Network >
Network Settings menu (20201.11).
2 Select the target network interface to set.
3 Press the [Edit] button.
A setup window for the selected network interface
a
ppears.
4 Press the [LAN] button and select a LAN to set from
the pull-down list.
The types of LAN which can be set will vary
depending
on the selected network interface.
When a LAN for redundancy is selected
The same settings as the main LAN are applied.
Proc
eed to step 11.
5 Press the [Mode] button for [IPv4] and select a setup
mode from the pull-down list.
Off: D
o not use IPv4.
Manual: Set
manually.
DHCP:
Set automatically using DHCP.
When [Off] or [DHCP] is selected, proceed to step 8.
6 Press the [Address] button for [IPv4] and enter an
address using the keyboard.
7 Press the [Prefix Length] button for [IPv4] and enter
a prefix length in the numeric keypad window.
8 Press the [Mode] button for [IPv6] and select a setup
mode from the pull-down list.
Off: D
o not use IPv6.
Manual: Set
manually.
Auto: Set
automatically using RA (Router
Advertisement).
DHCP:
Set automatically using DHCP.
When [Off], [Auto], or [DHCP] i
s selected, proceed
to step 11.
9 Press the [Address] button for [IPv6] and enter an
address using the keyboard.
10 Press the [Prefix Length] button for [IPv6] and enter
a prefix length in the numeric keypad window.
11 Press [OK].
12 Press the [Apply] button.
To return to the previous setting
Press the [Clear] button, check t
he message, then
press [OK].
13 Check the message, then press [OK].
Setting the Default Gateway
1 Open the System Configuration > Network >
Network Settings menu (20201.11).
2 Press the [Edit] button in the [Default Gateway]
group.
The [Default Gateway Settin
gs] window appears.
3 Press the [LAN] button for [IPv4] and select the
target LAN to set from the pull-down list.
Select [Ctrl LAN], [Util LAN1], [Util LAN2], [User
LA
N1], or [User LAN2].
When not using the IPv4 default gateway, select [No
Assign].
The [Mode] setting for [IPv4] is l
inked to the selected
LAN setting. When set to [Off] or [DHCP], proceed
to step
5 .
4 Press the [Address] button for [IPv4] and enter an
address using the keyboard.
5 Press the [LAN] button for [IPv6] and select the
target LAN to set from the pull-down list.
Select [Util LAN1], [Util LAN
2], [User LAN1], or
[User LAN2].
When not using the IPv6 default gateway, select [No
Assign].
The [Mode] setting for [IPv6] is l
inked to the selected
LAN setting. When set to [Off], [Auto], or [DHCP],
proceed to step
7 .
6 Press the [Address] button for [IPv6] and enter an
address using the keyboard.
7 Press [OK].
8 Press the [Apply] button.
To return to the previous setting
Press the [Clear] button, check t
he message, then
press [OK].
9 Check the message, then press [OK].