General
1-2
R
1.2 Application
The SOYER
®
stud welder BMS-10N with tip ignition allows you to weld pins
and threaded studs ranging from M3 - M8 or Ø 2 - 8 mm made of steel and
stainless steel and M3 - M8 or Ø 2 - 8 mm made of aluminium and brass
(depending on requirements), as well as a great number of various welding
fasteners (see chapter 2.4, Technical Data). It is also possible to weld welding
fasteners made of aluminium and brass.
The stud welder BMS-10NV with a charging capacity of 132,000 µF enables
you to weld steel studs up to M10.
The visual side of the workpiece is spared to a large extent from pressure
marks or deformations, so that even thin sheet metals under 1 mm sheet
thickness retain their decorative appearance.
If you need advice or assistance in solving problems, please contact either our
parent company or our field engineers.
1.3 Information on the product
Manufacturer Heinz Soyer Bolzenschweißtechnik GmbH
Etterschlag
Inninger Straße 14
D-82237 Wörthsee
Phone: ++49-(0) 81 53 / 8 85-0
Fax: ++49-(0) 81 53 / 80 30
E-Mail: verkauf@soyer.de
export@soyer.de
Product designation Stud welder BMS-10N
Stud welder BMS-10NV
Country of origin Germany
1.4 Type plate
The type plate is located on the rear side of the stud welder. It contains the
following information:
• Manufacturer's name
• Manufacturer's address
• Country of origin
• Product designation
• Method of welding
• Date of construction
• Production number
• Performance data
• Mains connection values
To Next Page
Loading...
