3-14
Safety instructions
R
3.7 Before starting welding ...
• Check the state of all cables before starting to weld.
• Immediately replace defective cables and cable connections.
• Ensure that the air apertures of the housing are not covered. Heat accumu-
lation may damage the stud welder.
3.8 Safety precautions at installation site
• When placing the stud welder on tables or similar workshop furniture,
ensure that the stud welding system stands firmly and that the table can
bear its weight.
• Make sure mains socket and stud welder are properly earthed.
• Comply with fire prevention regulations and do not weld in hazardous
locations.
• Make sure room is well ventilated or extract welding fumes, if necessary.
DANGER TO HEALTH
When welding, fumes and suspended matters may be generated . Beware
of fumes detrimental to health, particularly when using surface-treated
materials. If possible, only weld in rooms which are higher than 3 m. As per
VBG 15, special regulations are applicable for narrow rooms.
3.9 Working with the stud welder
• Comply with all accident prevention regulations which apply to the operation
of your stud welder
One of the accident prevention regulations applicable for stud
☞ welders is VBG 15 "Welding, cutting and similar working
methods". For more information, contact the Employer's
Liability Insurance Association.
MORTAL DANGER
When welding, do not wear clothes soiled with easily combustible
substances such as oil, grease and paraffin oil, etc.
To Next Page
Loading...
