3-15
Safety instructions
R
If an accident happens,
• switch off the stud welder and disconnect it from the mains supply
• call a doctor.
3.10 Safety instructions for maintenance, inspection and assembly
works
Only carry out maintenance The operator must ensure that all maintenance, inspection and assembly
works when stud welder has works are only carried out by authorized and qualified technical personnel.
been switched off
Generally, only work at the system when it has been switched off and after
having it disconnected from the mains supply. It is indispensable to comply
with the procedure for stopping the stud welding system described in the
operating instructions (chapter 3.13).
Immediately after having completed your work, re-install and activate all safety
and protective devices.
3.11 Unauthorized retrofit and spare parts production
The system may only be retrofitted and modified after consultation with the
manufacturer. Original spare parts and accessories authorized by the manufac-
turer guarantee safety. The use of other parts may result in the cancellation of
warranty for any consequences thus caused.
3.12 Inadmissible operating methods
Limit values Working safety of the stud welding system supplied can only be guaranteed if
the stud welder is used in accordance with its purpose. The limit values indi-
cated in the chapter "Technical data" must never be exceeded.
3.13 Stopping the stud welding system
3.13.1Stopping the stud welder when welding with normal operation
• Switch off the mains switch (item 2, chapter 5.1) of the stud welder.
• Disconnect the mains plug from the socket.
• Disconnect
- the earth cables (item 12, chapter 5.1)
- the control cable (item 10, chapter 5.1)
- the welding cable (item 11, chapter 5.1)
from the stud welder.
• Roll up the cables without buckling them.
To Next Page
Loading...
