Speco HRLN - Tampering

Alarm Management
DVR User Manual
58
② Enable or disable “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up Video” and “E-mail”. The alarm handling setting of object
detection alarm is like that of the sensor alarm (see 9.1 Sensor Alarm for details).
③ Click “Apply” to save the settings. You can click “Object Config” to go to the object detection configuration interface.
9.3.2 Tampering
Tampering Configuration:
① Click StartSettingsCameraIntelligent AnalyticsTampering to go to the following interface.
② Select the camera and enable the relevant detection as needed.
Scene Change: Alarms will be triggered if the scene of the monitor video has changed.
Video Blurred: Alarms will be triggered if the video becomes blurry.
Video Color Cast: Alarms will be triggered if the video becomes obscured.
③ Set the sensitivity of the exception detection.
④ Click “Apply” to save the settings.
⑤ Click “Processing Mode” to go to the alarm handling configuration interface of exception detection.
Exception Alarm Handling Configuration:
① Click StartSettingsAlarmIntelligence AlarmException to go to the interface.