Speco HRLN - Exception Alarm; IPC Offline Settings

Alarm Management
DVR User Manual
61
Click “Clear” to delete the alarm area.
⑤ Click “Apply” to save the settings.
⑥ Click “Processing Mode” to go to the alarm handling configuration interface of intrusion detection.
Intrusion Detection Alarm Handling Configuration:
① Click StartSettingsAlarmIntelligence AlarmIntrusion to go to the following interface.
② Enable or disable “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up Video” and “E-mail”. The alarm handling setting of intrusion
detection alarm is like that of the sensor alarm (see 9.1 Sensor Alarm for details).
③ Click “Apply” to save your settings. You can click “Intrusion Config” to go to the intrusion detection configuration interface.
9.4 Exception Alarm
9.4.1 IPC Offline Settings
① Click StartSettingsAlarmExceptionIPC Offline Settings to go to the interface as shown below.
② Enable or disable “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up Video”, “Pop-up Message Box” and “E-mail”. The IPC Offline
Settings are like that of the sensor alarm (see 9.1 Sensor Alarm for details).
③ Click “Apply” to save your settings.