STEP ET Series - Page 72

Chapter 7 Parameter Explanation
Shanghai Sigriner STEP Electric Co., Ltd.
- 62 -
Function
code
Function code name
Factory
default
Setting
range
Unit
Attrib
ute
Option description
1: Digital multi-segment speed
preset
3: Analog 0 set target speed
4: Analog 0 set current speed
5: Analog 1 set target speed
6: Analog 1 set current speed
8: PID set target speed
11: SSI preset current speed
12: Communication (Modbus)
preset target speed
15: Up/Down setting speed
17: PLC preset speed
Other channels: spare
P10.04
Torque preset mode
0
0~6
/
×
0: Panel preset torque
1: Analog quantity; 0 preset
target torque
2: Analog quantity; 1 preset
target torque
3: Standby
4: Standby
5: ModBus Preset torque
6: Spare
P10.05
Compensated torque
preset mode
0
0~6
/
×
0: Uncompensated torque
1: Set compensating torque
internally
2: spare
3:spare
4: spare
5: spare
6: spare
P10.06
Speed limits
0
0~5
/
×
0: Internal parameter limit
1-5: Spare
P10.07
Speed channel 2
0
0~17
/
×
Same as P10.03
6.2.2.2 Group P11 Start-up parameters
Function
code
Function code name
Factory
default
Setting
range
Unit
Attrib
ute
Option description
P11.00
Start modes
0
0~2
/
×
0: Normal start
1: DC braking and then start
2: Speed tracking start
P11.01
Start holding frequency
0.00
0.00~50.00
Hz
×
P11.02
Start frequency hold
time
0.0
0.0~3600.0
s
×
P11.03
Start DC injection
current
30.0
0.0~120.0
%
×
P11.04
Start DC injection time
5.0
0.0~100.0
s
×
P11.05
Excitation time
2.0
0.0~10.0
s
×
P11.06
Zero servo time
0.0
0.0~100.0
s
×