STEP ET Series - Page 94

Chapter 7 Parameter Explanation
Shanghai Sigriner STEP Electric Co., Ltd.
- 84 -
Figure 7-3 Three-wire Running Mode 1
3: 3-wire type 2
变频器
XC
24V
XV
X0(P30.00=7)
Xi
K3
K2
运转方向选择
反转
正转
K2
1
0
X1(P30.01=8)
K1
Inverter
Rotating direction
option
Forward rotation
Reverse rotation
Figure 7-4 Three-wire Running Mode 2
The Xi (i=2 - 7) terminal is set to "9: three-wire run control".
The rising edge of K1 terminal indicates the running command; the disconnection of K2 terminal
indicates the forward direction command; the closing of K3 terminal indicates the reverse direction
command; when K3 disconnects, the inverter will stop.
Function code
Name
Setting range
Factory setting
P10.02
Command channel selection
0~6
0
There are three different ways to set inverter running command.
0:Use operation panel to set running command Press the buttons on the operation panel, such as
Run (F 1), Stop (F 2) and LO/RE (F 3) to control the running, stop and forward/reverse rotation of
the inverter.
1:Use terminal to set running command The running, stop and forward/reverse rotation of the
inverter is performed by defining terminals X0 to X6. See P30.00 - P30.06 for description.
2:Use communication to set running command The running, stop and forward/reverse rotation of
the inverter is performed by Modbus communication. See Appendix Modbus Communication
Protocol.
5: PLC preset command When ProfiNet board card is configured, this control mode can be
selected.
6: SSL preset command When IO board card of SSI is configured, this control mode can be
selected.
Function code
Name
Setting range
Factory setting
P10.03
Speed channel 1
0~17
0
This function is applicable to frequency reference. See group P10.00 function code for the option of
control mode.
0:Panel digital frequency reference Set the frequency reference by P40.00, and users can increase
or decrease the frequency by ▲ and ▼ keys during the running. The setting will remain unchanged
when the machine is shutdown; and when the power supply fails, this setting will not maintain
unchanged.
1:Digital multi-speed setting target velocity The digital multi-speed terminals 0 - 3 are valid, and
the frequency is determined by the combination of this terminal. See P41.00 - P41.15.
3：A0 analog target speed preset