Steris Basil 4600 - Programming Cycle Values

5-3
Cycle Programming Operator Manual 122997-341
5.3 Programming
Cycle Values
1. Set POWER-OFF/STANDBY switch, located behind printer door,
to POWER. Unit name temporarily appears on screen then
display shows first cycle menu:
CYCLE 1
CYCLE 2
CYCLE 3 CYCLE 4
__indicates flashing position.
2. Press CYCLE MENU touch pad until desired cycle menu
appears on screen. Display shows:
CYCLE 9
CYCLE 10
CYCLE 11 CYCLE 12
__indicates flashing position.
3. Press SELECT CYCLE touch pad until desired cycle name
flashes. Display shows:
CYCLE 9 CYCLE 10
CYCLE 11 CYCLE 12
__indicates flashing position.
4. When desired cycle name is flashing, press CHANGE VALUES
touch pad to access Change Values mode. Printer records:
* CHANGE VALUE 8:44:51A
And first Change Values screen appears:
CHANGE CYCLE NAME
C
YCLE 10
__indicates flashing position.
NOTE: For Change Values mode, note the following:
1) If Access Code feature is enabled and the selected cycle is
locked out, the Access Code sequence appears after CHANGE
VALUES is pressed.
2) Change Values mode may be exited at any time by pressing
SAVE VALUES. Control saves changed values and returns
screen to selected cycle menu.
To change cycle name, press CURSOR (left or right) touch pad
to advance flashing position one space at a time. Press VALUE
(up or down) touch pad to select desired letter, number,
punctuation or space. Cycle name can be a maximum of nine
characters including spaces.
NOTE: Pressing CURSOR touch pad or VALUE touch pad
repeatedly in one direction cycles through all available positions
or letters and numbers.
5. Press CHANGE VALUES touch pad. Bottle Washing option
screen appears:
BOTTLE WASHING
NO
__indicates flashing position.
6. Press VALUE (up or down) touch pad to toggle between YES
and NO. Selecting NO disables bottle wash option. Selecting
YES enables bottle wash option.
SELECT
CYCLE
CHANGE
VALUES
CURSOR
VALUE
CHANGE
VALUES
VALUE