Steris Basil 4600 - Extend Cycle Phase Time; During a Cycle; Prior to Starting a Cycle

4-20
122997-341 Operator Manual Washer Operation
4.7 Extend Cycle
Phase Time
Cycle phase times may be temporarily extended by pressing Extend
Phase touch pad either while cycle is in progress or prior to initiating
cycle during cycle program review. Temporarily extended phase
times apply only to immediate cycle selected. On completion of
cycle, phase times return to programmed setpoints.
4.7.1 During a Cycle After starting a cycle, programmed time for each phase may be tem-
porarily extended only when particular phase process is in opera-
tion.
CYCLE 6 182.7F
RINSE 2 T= 1:30
To extend phase time, press EXTEND PHASE touch pad while
actual phase process (i.e., recirculating, exhausting) is in operation.
Each time touch pad is pressed, programmed time setpoint is added
to phase time remaining:
CYCLE 6 182.7F
RINSE 2 ET= 2:00
... and printer records:
RINSE 1 4:09:49 182.6
4:11:19P 182.5
RINSE 2 4:14:10P 182.7
RINSE 2 PHASE EXT. 4:15:39P
4:17:39P 182.4
F. RINSE 4:20:22p 182.6
NOTE: Filling and draining functions are not affected by extend
phase feature. If EXTEND PHASE touch pad is pressed during these
functions, cycle continues as programmed.
4.7.2 Prior to Starting a Cycle
1. Once desired cycle is selected, press REVIEW CYCLE touch
pad to access Cycle Review mode. Continue to press REVIEW
CYCLE touch pad to advance screen to desired phase.
CYCLE 6 SP=180.0F
RINSE 2 T=01:30
2. With correct cycle phase displayed, press EXTEND PHASE.
Programmed phase time is temporarily doubled. If Extend Phase
is pressed again, phase time returns to original programmed
time setpoint.
CYCLE 6 SP=180.0F
RINSE 2 ET=03:00
NOTE: While in Cycle Review mode, pressing EXTEND PHASE
touch pad only allows operator to double programmed phase
EXTEND
PHASE
EXTEND
PHASE