7-1
Troubleshooting Operator Manual 122997-341
This section contains detailed information on types of washer mal-
functions likely to occur, and possible causes and corrective actions.
If you are unable to correct problem with use of the following Trou-
bleshooting Charts, or if a problem occurs that is not described on
chart, please call STERIS. A factory-trained technician will promptly
place your washer in proper working condition.
NOTE: Never permit unqualified persons to service washer.
Table Descriptions
Table 7-1 – Problems where NO alarm or printout occur.
Table 7-2 – Problems where alarm and/or printout occur.
WARNING – PERSONAL
INJURY AND/OR EQUIP-
MENT DAMAGE HAZARD:
Only STERIS or STERIS-
trained service personnel
should make repairs and
adjustments to this equip-
ment. Maintenance done by
inexperienced, unqualified
personnel or installation of
unauthorized parts could
cause personal injury, inval-
idate warranty, or result in
costly damage. Contact
STERIS regarding Service
options.
WARNING – ELECTRIC
SHOCK AND/OR BURN HAZ-
ARD: Disconnect all utilities
to washer before servicing.
Do not service washer
unless all utilities have been
properly locked out. Always
follow local occupational
health and safety regula-
tions, as well as electric and
plumbing codes.
WARNING – BURN HAZ-
ARD: Allow unit to cool
down before performing any
service on mechanical com-
ponents and on piping.
Components and piping
become very hot during
operation.
TROUBLESHOOTING
To Next Page
Loading...
