Steris Basil 4600 - Programming Values with Access Code Enabled

5-11
Cycle Programming Operator Manual 122997-341
5. Press CHANGE VALUES touch pad. Printer enabling screen
appears:
PRINTER ENABLED?
NO
__indicates flashing position.
6. Press VALUE (up or down) touch pad to toggle between YES
and NO answer. Select YES to enable printer, NO to disable it.
7. Press CHANGE VALUES touch pad. Date and Time screen
appears:
DATE M
M/DD/YY
TIME HH:MM:SSA
__indicates flashing position.
8. To enter correct date and time, press CURSOR (left or right)
touch pad to advance flashing position one space at a time.
Press VALUE (up or down) touch pad to select desired number
(0-9). Date is input as two-digit numerical values for Month/Day/
Year. Time is input as Hour/Minute/Second.
NOTE: When setting the date and time, note the following:
1) Pressing CURSOR touch pad or VALUE touch pad repeatedly
in one direction cycles through all available positions or letters
and numbers.
2) If Access Code feature is enabled and selected cycle is not
locked out, Access Code sequence appear after Date and Time
screen (see S
ECTION 5.5, PROGRAMMING VALUES WITH ACCESS
CODE ENABLED).
9. Press SAVE VALUES touch pad to save miscellaneous value,
exit Change Values mode and return screen to cycle menu.
NOTE: At this point, pressing Change Values also saves all
changed operating values, exit Change Values mode and return
screen to cycle menu.
5.5 Programming
Values with Access
Code Enabled
Access code feature is used to prevent unauthorized changes to
parameters of designated cycles and/or operating values by unau-
thorized operators. With this feature, access to cycle values may be
selectively limited to authorized operators only, depending on secu-
rity needs of washer environment. When access code is enabled,
only authorized operators can change operating values.
ADVANTAGES OF ENABLING OR DISABLING ACCESS CODE:
Enabling or disabling access code can impact efficiency of washing
operations. For that reason, supervisor should carefully consider
choices: if access code is ON, supervisor can ensure operators use
washer within predetermined parameters; if access code is OFF,
supervisor can allow operators more flexibility in determining which
cycles to use and how to use them. Deciding factor should be what
works best for facility’s operation.
CHANGE
VALUES
VALUE
CHANGE
VALUES
CURSOR
VALUE
SAVE
VALUES