7-5
Troubleshooting Operator Manual 122997-341
Table 7-2. Operator Troubleshooting Chart - Alarm and/or Printout
PROBLEM POSSIBLE CAUSE AND/OR CORRECTION
1. Display shows:
STOP BUTTON PRESSED!
PUSH START TO RESUME
... and printer prints:
ALARM: HH:SS:MM
STOP BUTTON PRESSED!
STOP/RESET touch pad pressed – press CYCLE/START touch
pad to resume cycle operation, or press STOP/RESET touch pad
again to abort cycle operation.
2. Display shows:
LOAD DOOR
OPEN WHEN PROCESSING
... and printer prints:
ALARM HH:MM:SS
LOAD DOOR
OPEN WHILE PROCESSING
1. Load-side door open – close and latch door. Press CYCLE/
START touch pad to resume cycle operation.
2. If condition reoccurs, call Service.*
3. Display shows:
UNLOAD DOOR
OPEN WHEN PROCESSING
... and printer prints:
ALARM HH:MM:SS
UNLOAD DOOR
OPEN WHILE PROCESSING
1. Unload-side door open – close and latch door. Press CYCLE/
START touch pad to resume cycle operation.
2. If condition reoccurs, call Service.*
4. Display shows:
SUMP
TOO LONG IN FILL
... and printer prints:
ALARM HH:MM:SS
SUMP
TOO LONG IN FILL
1. Supply valves not fully open – open building and washer supply
valves.
2. Foam in chamber – rinse chamber with cold water and decrease
detergent injection rate.
3. If situation reoccurs, call Service.*
5. Display shows:
SUMP
TOO LONG IN DRAIN
... and printer prints:
ALARM HH:MM:SS
SUMP
TOO LONG IN DRAIN
1. Self-cleaning screen clogged – remove debris from screen.
2. If situation reoccurs, call Service.*
* Service Charges may be incurred. Consult your warranty for details.
To Next Page
Loading...
