Lubricate the lift mast and chains
with chain spray
NOTE
If there is excessive dust on the chain affect-
ing the ability of the lubricant to permeate the
chain, the lifting chain must be cleaned.
– Place an oil collecting trough under the lift
mast
– Carry out cleaning with an alkyl derivative
such as an industrial diesel fuel cleaning
agent (please comply with the manufactur-
er's safety instructions).
– Additives may not be used if using a steam
nozzle.
– Immediately blow the chain dry after clean-
ing to remove water both on the chain sur-
face and inside the hinge pins. Move the
chain several times during the blow-drying
process.
– Immediately apply chain spray and keep the
chain moving while doing so.
NOTE
The lifting chains are a safety component. The
use of cold cleaning agents, chemical cleaning
agents, corrosive liquids or liquids containing
acid or chlorine will cause direct damage to
the chains.
Use and operation
4
Cleaning
9560128011601 EN - 03/2020
To Next Page
Loading...
