– Reduce the driving speed on descending
gradients.
It is not permitted to drive on long ascending
and descending gradients greater than 15%
due to the specified minimum braking and sta-
bility values.
– Before driving on ascending and descend-
ing gradients greater than 15%, consult the
authorised service centre.
The process of placing loads into stock and
removing loads from stock while on an as-
cending or descending gradient is not permit-
ted!
– Always place loads into stock and remove
loads from stock on a horizontal plane.
Driving on lifts
The driver may only use this truck on lifts with
a sufficient rated capacity and for which the
operating company has been granted authori-
sation.
DANGER
There is a risk to life if you are crushed or run over
by the truck.
– There must be no personnel already in the lift
when the truck is driven into the lift.
– Personnel are only permitted to enter the lift once
the truck is secure, and must exit the lift before
the truck is driven out.
5060_003-071
Use and operation
4
Handling loads
8560128011601 EN - 03/2020
To Next Page
Loading...
