Still RCD40 User Manual

Changing the fuel filter cartridge
– Loosen and unscrew filter with tool.
– Collect escaping fuel.
– Clean the sealing surface of the filter carrier
with a clean, lint-free cloth.
– Oil the seal of the new original spare filter
lightly.
– Screw on new filter by hand until the gasket
is touching and tighten.
Tightening torque:
10 Nm - 12 Nm
– Vent the fuel system.
Replacing the water trap
– Turn off the engine and allow it to cool
down.
– Close all oil valves.
– Disconnect the water trap sensor connector
(4).
– Place a container under the water trap.


Maintenance
5
Maintenance service
12160128011601 EN - 03/2020

Still RCD40 Specifications

General

Brand	Still
Model	RCD40
Category	Forklifts
Language	English