Still RCD40 User Manual

Attachments
Attachments shall only be used as permitted.
The driver shall be instructed in the handling
of attachments.
The attachment operating instructions are en-
closed for trucks that are delivered from the
factory with an attachment. Before commis-
sioning a truck with an attachment, you must
check that loads are handled securely. De-
pending on the type of attachment, it may be
necessary to make adjustments, e.g. pressure
settings or adjusting stops and operating
speeds. See the attachment operating instruc-
tions for the corresponding instructions.
If attachments are not supplied with the indus-
trial truck, the specifications of the industrial
truck manufacturer and the attachment manu-
facturer must be observed.
The attachments and the connection of power
supplies for powered attachments may only be
made by specialists in accordance with the
specifications of the manufacturer. The proper
functioning of the attachments shall be
checked after each installation before initial
use.
The permissible carrying capacity of the at-
tachments and the permitted load of the indus-
trial truck (carrying capacity and load moment)
combined with the attachments shall not be
exceeded., refer to additional capacity rating
plate.
Modifications, in particular attachments or
conversions, are not permitted to be made to
the industrial truck without the manufacturer’s
approval.
Trailers
Industrial trucks may only be used to tow trail-
ers if they are intended for this purpose by the
manufacturer and if they are fitted with the ap-
propriate trailer coupling. The maximum towed
load specified in the operating instructions for
unbraked or braked trailers must not be ex-
ceeded.
The towing industrial truck must be operated
in such away that safe driving and braking of
the towed vehicle is ensured for all driving
movements.
Impermissible use
DANGER
High risk of property damage, injury and death.
Avoid impermissible use.
The operating company or driver, and not the
manufacturer, is liable if the truck is used in a
manner that is not permitted.
The following list is exemplary and is not in-
tended to be exhaustive.
It is not permitted:
●
To use the truck to transport people (if the
truck is not designed for this purpose)
●
in areas where there is a risk of fire of ex-
plosion
●
for stacking/unstacking operations on
slopes
●
To stand on the fork arms when raised
●
To exceed the truck's maximum load ca-
pacity
●
To increase the truck's load capacity, e.g.
by attaching an additional weight.
Introduction
1
Impermissible use
4 60128011601 EN - 03/2020

Still RCD40 Specifications

General

Brand	Still
Model	RCD40
Category	Forklifts
Language	English