Still RCD40 - Checking the engine oil level

The radiator is assembled with coolant level
sensor. The corresponding light in the display
will illuminate while the coolant is too low, fill in
the radiator with specified coolant accordingly.
– Screw the radiator cap back on securely.
Checking the engine oil level
– Stop the truck and ensure it is parked on a
level surface.
– Open the bonnet.
– Take out the dipstick (1) and wipe with a
clean cloth.
– Fully reinsert the dipstick.
– Remove the dipstick. The oil level should be
between the upper (2) and lower (3) mark-
ings on the dipstick.
NOTE
If necessary, open the oil filler cap (4) and add
oil.
– Fully reinsert the dipstick.


Use and operation
4
Remaining ready for operation
48 60128011601 EN - 03/2020