EasyManuals Logo

Still RCD40 User Manual

Still RCD40
170 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #142 background imageLoading...
Page #142 background image
intake opening after the warning light illumi-
nates.
Changing the hydraulic transmis-
sion crude oil filter
ENVIRONMENT NOTE
Please follow the instructions for disposal of
fluids and lubricants.
NOTE
Place a container under the crude oil filter to
collect oil flowing out of the transmission.
Remove the floor plate.
Unscrew the fastening screws and washers
on the crude oil filter.
Slowly pull out the crude oil filter so that the
oil flows into the container.
Unscrew the crude oil filter from the oil filter
seat.
Unscrew the fastening nut on the crude oil
filter; then remove the filter insert.
Replace it with a new crude oil filter insert.
Fit the filter insert followed by the bottom
cover onto the filter spindle; then tighten the
nut.
Refit the crude oil filter to the gearbox using
the fastening screws.
Refit the floor plate.
Maintenance
5
Maintenance service
132 60128011601 EN - 03/2020

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Still RCD40 and is the answer not in the manual?

Still RCD40 Specifications

General IconGeneral
BrandStill
ModelRCD40
CategoryForklifts
LanguageEnglish

Related product manuals