Introduction
Operation manual
ID 442233.05
WE KEEP THINGS MOVING
5
1
1Introduction
1.1 Purpose of the manual
This manual describes the POSITool software. The following topics are included:
• A discussion of the installation
• Explanations of the structure of the software
• The levels which can be set
• The communication between inverter and PC
• The diagnostic functions
1.2 Other manuals
You can find information on the POSITool software in the following manuals:
Note that the programming functionality of POSITool can only be used after
training by STÖBER ANTRIEBSTECHNIK. You can find information on training at
www. stoeber.de
The documentation of the MDS 5000 includes the following manuals:
The documentation of the FDS 5000 includes the following manuals:
Manual Contents ID Latest version
a)
POSITool operating manual Information on the
basic functions of
POSITool
442233 V 5.6-H
Programming manual Information on
programming with
POSITool
441693 V 5.6-H
a) At the time of publication. You can find all versions at www.stoeber.de > Products > Doc Center.
Manual Contents ID Latest version
a)
Commissioning Instructions Reinstallation, replacement, function test 442297 V 5.6-H
Projecting manual Installation and connection 442273 V 5.6-H
Operating manual Set up the inverter 442285 V 5.6-H
a) At the time of publication. You can find all versions at www.stoeber.de > Products > Doc Center.
Manual Contents ID Latest version
a)
Commissioning Instructions Reinstallation, replacement, function test 442293 V 5.6-H
Projecting manual Installation and connection 442269 V 5.6-H
Operating manual Set up the inverter 442281 V 5.6-H
a) At the time of publication. You can find all versions at www.stoeber.de > Products > Doc Center.
To Next Page
Loading...
