Setup of POSITool
Operation manual
ID 442233.05
WE KEEP THINGS MOVING
19
5
5.4 IGB Entry
In order for POSITool to communicate via IGB with one or more inverters of device
series SDS 5000, an IGB entry must be available in the project and the SDS 5000
must be assigned to the IGB entry.
5.4.1 Create an IGB entry
Remember that only one IGB per project may be present. An IGB entry is
automatically created when you set up a new project with an SDS 5000. To create
an IGB entry later, proceed as shown below:
5.4.2 Allocate an SDS 5000 to an IGB
To allocate one or more SDS 5000s to an IGB, proceed as shown below:
You have two further method of opening the IGB properties dialog:
• Right-click the IGB entry and then select Properties in the context menu.
• In the File menu, select the Manage IGB entry. Press the Properties button in
the Manage IGB dialog.
You can also change the IGB designation and delete the IGB in the Manage IGB
dialog.
Create an IGB entry
1. Open the menu File.
2. Select the menu item New IGB.
A dialog screen for entering the IGB designation appears.
3. Enter the designation of the IGB.
4. Confirm the dialog screen with the OK button.
The IGB entry appears under your designation in the project view.
Allocate an SDS 5000 to an IGB
1. Double click the IGB entry.
The IGB properties dialog screen appears. The SDS 5000s of the project
are shown here.
2. Click the check boxes of the SDS 5000s which are to be allocated to the IGB.
3. Confirm the dialog screen with the OK button.
The allocated SDS 5000s now appear under the IGB in the project view.
To Next Page
