EasyManuals Logo

Stober SC6 Series Commissioning Instructions

Stober SC6 Series
74 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
3 | General safety instructions STÖBER
12
11/2017 | ID 442793.00
3.3 Intended use
As defined by DIN EN 50178, SC6 drive controllers are electrical devices operating as power
electronics to control the flow of energy in high-voltage systems.
They are intended solely for the operation of STOBER LM series Lean motors, synchronous
servo motors (e.g. from the STOBER EZ series), asynchronous motors or torque motors.
The connection of other electronic loads constitutes improper use.
3.4 Transport and storage
Inspect the delivery for any transport damage immediately after you receive it. Notify the
transport company of any damage immediately. Do not put a damaged product into operation.
To ensure the faultless and safe operation of the products, they must be professionally set up,
installed, operated and maintained. If you have to transport or store the products, you must
protect them from mechanical impacts and vibrations as well as observe the recommended
transport and storage conditions in the technical data.
Store the products in a dry and dust-free room if you do not install them immediately.
3.5 Operational environment and operation
The products are subject to sales restrictions in accordance with IEC 61800-3.
The products are not designed for use in a public low-voltage network that supplies residential
areas. Radio-frequency interference can be expected if the products are used in this type of
network.
The products are designed exclusively for operation in TN networks.
The products are intended exclusively for installation in control cabinets with at least protection
class IP54.
Always operate the products within the limits specified by the technical data.
The following applications are prohibited:
§ Use in potentially explosive atmospheres
§ Use in environments with harmful substances as specified by EN 60721, such as oils, acids,
gases, vapors, dust and radiation
Implementation of the following applications is permitted only after approval from STOBER:
§ Use in non-stationary applications
§ The use of active components (drive controllers, supply modules, energy recovery units or
discharge units) from third-party manufacturers

Table of Contents

Other manuals for Stober SC6 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Stober SC6 Series and is the answer not in the manual?

Stober SC6 Series Specifications

General IconGeneral
BrandStober
ModelSC6 Series
CategoryController
LanguageEnglish

Related product manuals