Stober SC6 Series Commissioning Instructions

STÖBER 8 | Commissioning
11/2017 | ID 442793.00
61
Projecting the drive controller
1. Properties tab:
Establish the relationship between your circuit diagram and the drive controller to be
projected in DriveControlSuite.
Reference: Specify the reference code (equipment code) of the drive controller.
Designation: Give the drive controller a unique name.
Version: Version your project configuration.
Description: If necessary specify supporting additional information such as the change
history of the project configuration.
2. Drive controller tab:
Select the SC6 series and the device type of the drive controller.
3. Option modules tab:
Safety module: If the drive controller is part of a safety circuit, select the SR6 or SY6 safety
module.
4. Device controller tab:
Device controller: Select the device controller that defines the underlying activation signals
for the drive controller.
Rx process data, Tx process data: If you control the drive controller using a fieldbus, select
the fieldbus-specific receive and send process data.
If you operate the drive controller in combination with the SY6 safety module, select
EtherCAT Rx and EtherCAT Tx for transmitting the EtherCAT process data.
If you operate the drive controller in combination with the SR6 safety module or without
safety technology (SZ6), the fieldbus connection is optional. If you do not use a fieldbus,
project No transmission.
Projecting the axis
1. Click on Axis 1.
2. Properties tab:
Establish the connection between your circuit diagram and the axis to be projected in
DriveControlSuite.
Reference: Specify the reference code (equipment code) of the axis.
Designation: Give the axis a unique name.
Version: Version your project configuration.
Description: If necessary specify supporting additional information such as the change
history of the project configuration.
3. Application tab:
Select the desired control or drive-based application.
4. Motor tab:
Select the motor category, the series and the type of motor operated using this axis. If you
are working with motors from third-part suppliers, enter the accompanying motor data at a
later time.
5. Repeat steps 2 – 4 for the 2nd axis (only for double-axis controllers).
6. Confirm with OK.

Stober SC6 Series Specifications

General

Brand	Stober
Model	SC6 Series
Category	Controller
Language	English