IMPORTANT
Never dismantle your Stormshield appliance, as doing so may cause hardware accidents
and/or bodily harm.
IMPORTANT
Do not insert objects into the appliance’s vents – this may hinder the rotation of an internal
fan or damage it, causing the appliance to overheat. This may also cause a short-circuit
that may lead to the breakdown of the appliance.
IMPORTANT
Copper Ethernet cables connected to your Stormshield Network Firewall must not be
connected to other appliances located in other buildings.
As per legal safety requirements, anyone performing any operation on a Stormshield Network SN-
range product must know and follow the safety indications below:
To the attention of maintenance teams:
WARNING
DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY WITH SAME
OR EQUIVALENT TYPE RECOMMENDED BY THE MANUFACTURER. DISCARD USED BATTERIES
ACCORDING TO THE MANUFACTURER’S INSTRUCTIONS.
Only qualified personnel from an approved maintenance center can perform operations on
this component.
In the event of hardware problem with your Firewall or if one of the elements does not match its
description, please contact your certified partner.
Installing an appliance outside a rack
Your product must be equipped with its non-slip rubber feet in order to reduce the possibility of
your appliance slipping off the surface on which it has been installed.
These flexible non-slip rubber feet are to be attached to the underside of the chassis for SN510,
SN710 and SN910 models. Please refer to the section INSTALLATION PRECAUTIONS for further
information.
Assembly in a cabinet
For a racked installation, place heavier appliances in the lower section of the rack and lighter
elements in the higher section.
Refer to the section INSTALLATION IN A 19” CABINET for details on how to install an appliance in a
racking bay.
Precautions
l Installation kit - for rack mounting the original installation kit for this device has to be used.
l Elevated Operating Ambient Temperature - If installed in a closed or multi-unit rack assembly,
the operating ambient temperature of the rack environment may be greater than room
ambient. Therefore, consideration should be given to installing the equipment in an
environment compatible with the maximum ambient temperature (Tma) specified by the
manufacturer.
l Reduced Air Flow - Installation of the equipment in a rack should be such that the amount of
air flow required for safe operation of the equipment is not compromised.
SNS - PRODUCT PRESENTATION AND INSTALLATION 2019
SAFETY RULES
Page 12/66 sns-en-SNrange_installation_guide-2019 - 09/2019
To Next Page
Loading...
