Connecting to a 24VDC power supply unit (SNi40)
The supported voltage ranges from 12VDC to 36VDC.
REMINDER
Equipment has to be installed by a qualified electrician.
NOTE
You are strongly advised to connect all appliances to a "UPS" device. The SNi40 model is
equipped with a redundant power supply unit, so you are advised to connect it to 2
independent sources of power.
NOTE
In the event of an accidental power outage, the product will automatically start up once it is
powered up again.
NOTE
A power adapter may be ordered separately.
Connecting to the network
All models are fitted with RJ45 Gigabit Ethernet ports by default.
The SN910 and SNi40 models offer by default, two SFP sockets, allowing the insertion of SFP
transceivers, provided as an option.
The SN6100 model offers by default, two SFP+ sockets, allowing the insertion of SFP+
transceivers, provided as an option.
SN710, SN910, SN2100, SN3100 and SN6100 models also offer one or several slots for various
types of extension modules, depending on the module reference ordered, that allow adding
Ethernet ports:
l RJ45 copper, or module for SFP transceivers,
l or module for SFP+ transceivers,
l or module for QSFP+ transceivers,
A slot is available on SN710 and SN910 models, three on SN2100 and SN3100 appliances, and
eight on the SN6100.
IMPORTANT
Use only Stormshield Network-approved SFP (1Gbps), SFP+ (1Gbps /10Gbps) or QSFP+
(40Gbps) transceivers available in the catalogue.
For information on the type of network cable to choose according to the network port and the
selected connectors, see the sections Extension modules (SN710 and upwards) and Fiber
Ethernet connectors.
For information on which connectors to use for high availability links, please refer to
Recommended connectors for high availability (HA) links
SNS - PRODUCT PRESENTATION AND INSTALLATION 2019
INSTALLATION PRECAUTIONS
Page 18/66 sns-en-SNrange_installation_guide-2019 - 09/2019
To Next Page
Loading...
