IMPORTANT
Avoid in particular direct exposure to sunlight. Always keep an adequate distance around
the appliance in order to guarantee a free flow of air, thereby preventing the possibility of
overheating.
IMPORTANT
Do not place objects on your Stormshield Network appliance.
IMPORTANT
The Stormshield Network Firewall has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the Firewall is operated in
a commercial environment. The Stormshield Network Firewall generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of
this Firewall in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
The Stormshield Network Firewall complies with the requirements set out in the European
standard EN55032, Class A. In a residential environment, a Class A product may cause
radioelectric interference, for which the user may need to take appropriate measures.
Connecting to the mains
The supported voltage ranges from 100V to 240V.
NOTE
You are strongly advised to connect all appliances to a UPS device. As SN3100 and
SN6100 models are equipped with redundant power supplies (option offered on SN2100
models), plugging them into 2 separate mains circuits is recommended.
NOTE
In the event of an accidental power outage, the product will automatically start up once it is
powered up again.
NOTE
For SN2100, SN3100 and SN6100 models, 48V DC power supply modules may be
provided separately upon request.
For SN160, SN160W, SN210, SN210W and SN310 models, insert the connector of the power
adapter into the power socket on the rear panel of the Firewall. Next, connect the adapter to an
appropriate mains socket using the power cord provided.
For SN510, SN710, SN910 and SN2100 models, insert the plug of the power cord (provided with
the product) into the power socket on the rear panel of the appliance. Next, plug the other end of
the power cord into an appropriate mains socket.
For SN3100 and SN6100 models, insert the connector of both power cords provided into both
power sockets located on the rear panel of the Firewall. Next, plug in the other ends of the power
cords into appropriate mains sockets.
SNS - PRODUCT PRESENTATION AND INSTALLATION 2019
INSTALLATION PRECAUTIONS
Page 17/66 sns-en-SNrange_installation_guide-2019 - 09/2019
To Next Page
Loading...
