the replacement SSD obtained from your partner, until you hear a click. Once you have inserted
the new SSD, type the following command to scan this new SSD: nraid –z.
Next, type the command to rebuild the RAID: nraid -r
RAID option (SN2100)
On the SN2100 model, the RAID option can be subscribed in order to add a second SSD and build
a RAID1 on it.
This procedure is to be carried out on an appliance that is running:
l In console mode, type the following command to build the RAID: nraid -c
l Unlock the rack with the lever, then pull out the empty canister (lower canister, LEDs off).
Insert the new canister with the optional SSD obtained from your partner, until you hear a
click.
l Once you have inserted the new SSD, type the following command to scan this new SSD:
nraid –z
l Then type the following command in order to replicate the data on the RAID: nraid -r
Big Data option (SN2100, SN3100 and SN6100)
If you have subscribed the Big Data option(available on SN2100, SN3100 and SN61000
models), the original SSDs will be replaced with SSDs of greater capacity.
After you have shut down the appliance, you will be able to extract the SSDs. Unlock the rack with
the levers, then pull out both SSD canisters. Insert the new canisters with the replacement SSDs
obtained from your partner, until you hear a click. They will be detected the next time you start
the appliance.
SNS - PRODUCT PRESENTATION AND INSTALLATION 2019
APPENDIX C: MANAGING SSDS
Page 60/66 sns-en-SNrange_installation_guide-2019 - 09/2019
To Next Page
Loading...
