l Mechanical Loading - Mounting of the equipment in the rack should be such that hazardous
conditions due to uneven mechanical loading are avoided.
l Circuit Overloading - Consideration should be given to the connection of the equipment to the
supply circuit and the effect that overloading of the circuits might have on overcurrent
protection and supply wiring. Appropriate consideration of equipment nameplate ratings
should be used when addressing this concern.
l Reliable Earthing - Reliable earthing of rack-mounted equipment should be maintained.
Particular attention should be given to supply connections other than direct connections to
the branch circuit (e.g. use of power strips).
l Leakage current - considerations should be given to the summation of leakage currents when
installing the equipment in a closed or multi-unit rack assembly.
SNi40 model
Before plugging in any devices
l Ensure that your Stormshield product and its accessories are not damaged.
l Ensure that the electrical characteristics of your product indicated on the product label are
compatible with those of your power supply network.
l The chassis of your product must be connected to a protective earth circuit, using rated
minimum 16 AWG or 1 mm² wire. Ensure that the connection is permanent and reliable, and
that the protective earth circuit of your installation complies with safety standards in force.
l Before installing or removing your product, ensure that it has been turned off, and that all
power supply connections have been removed.
l Equipment connected to a DC mains supply: please follow IEC, NEC, ANSI/NFPA 70 and CEC,
Part I, C22.1 for all relevant field wiring instructions and cautions. The equipement must be
installed by a qualified electrician.
l The equipment shall be connected to the DC mains supply with an approved switch or
breaker and easily accessible.
l Only wires rated minimum 16AWG or 1mm² shall be used to connect the equipment to the DC
mains supply.
Warranty and safety rules
Under no circumstances should you take apart a Stormshield Network appliance on your own.
Only Stormshield, which markets the Stormshield Network range, and its approved maintenance
agents are authorized to do so. A seal label protects all Stormshield Network Firewalls from being
opened.
Your warranty will be rendered null and void should you dismantle a Stormshield Network
Firewall on your own.
SNS - PRODUCT PRESENTATION AND INSTALLATION 2019
SAFETY RULES
Page 13/66 sns-en-SNrange_installation_guide-2019 - 09/2019
To Next Page
Loading...
