IMPORTANT
Never dismantle your Stormshield appliance, as doing so may cause hardware accidents
and/or bodily harm.
IMPORTANT
Copper Ethernet cables connected to your Stormshield Network Firewall must not be
connected to other appliances located in other buildings.
As per legal safety requirements, anyone performing any operation on a Stormshield Network SN-
range product must know and follow the safety indications below:
To the attention of maintenance teams:
WARNING
DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY WITH SAME
OR EQUIVALENT TYPE RECOMMENDED BY THE MANUFACTURER. DISCARD USED BATTERIES
ACCORDING TO THE MANUFACTURER’S INSTRUCTIONS.
Only qualified personnel from an approved maintenance center can perform operations on
this component.
In the event of hardware problem with your Firewall or if one of the elements does not match its
description, please contact your certified partner.
Assembly in a cabinet
l Installation kit - Only use the installation kit supplied with the product.
l Elevated Operating Ambient - If installed in a closed or multi-unit cabinet assembly, the
operating ambient temperature of the cabinet environment may be greater than room
ambient. Therefore, consideration should be given to installing the equipment in an
environment compatible with the maximum ambient temperature (Tma) specified by the
manufacturer.
l Reduced Air Flow - Installation of the equipment in a cabinet should be such that the amount
of air flow required for safe operation of the equipment is not compromised.
l Mechanical Loading - Mounting of the equipment in the cabinet should be such that a
hazardous condition is not achieved due to uneven mechanical loading.
l Circuit Overloading - Consideration should be given to the connection of the equipment to the
supply circuit and the effect that overloading of the circuits might have on overcurrent
protection and supply wiring. Appropriate consideration of equipment nameplate ratings
should be used when addressing this concern.
l Reliable Earthing - Reliable earthing of cabinet-mounted equipment should be maintained.
Particular attention should be given to supply connections other than direct connections to
the branch circuit (e.g. use of terminal blocks).
SNS - PRODUCT PRESENTATION AND INSTALLATION 2019
SAFETY RULES
Page 14/66 sns-en-SNrange_installation_guide-2019 - 09/2019
To Next Page
Loading...
