EasyManua.ls Logo

Stormshield SN310 - SNi40 Hard Disk Removal and Reassembly; SNi40 Hard Disk Removal; SNi40 Reassembly

Stormshield SN310
66 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SN310 model
The SN310 firewallis fanless.Theproductcomes with an external power adapter.
LEDs Front panel:
This model has its LEDs on the front panel as shown below:
1 Online LED (green)
2Status LED (green)
3 Power LED (yellow)
1 OUT Interface
2 INInterface
Connectors
The connectors on the SN310 model are located on the front and rear panels.
1 This is the slot for the SD card*.
2 Plugging in the mains adapter automatically starts this product.
3 The USB port allows accessing the product in console mode**; it is possible to connect the
Firewall directly from a computer. The default baud rate on these models is 115 200 baud
(8N1).
4 The USB 3.0 port can be used for secure configurations or upgrades. You can also plug a USB
key or an approved USB modem into it.
5 The USB 2.0 port can be used for secure configurations or upgrades. You can also plug a USB
key or an approved USB modem into it.
The SN310 model offers 8 1GbE ports:
6 The first zone is the EXTERNAL (OUT) interface, in external mode by default. It makes up the
zone that is needed for connecting to the internet.
7 The second zone is the INTERNAL (IN) interface.
8 This is the button for resetting the appliance to its factory settings (defaultconfig).
* The recommended type of SD card isat least Class10 (C10)UHS Class1 (U1) or App Performance 1
(A1),SDHC standard. The memory card must be in a full-size physical SD format, in SDHC or SDXC standard.
Onlyadaptersprovided withthe card must be used. The maximummemory size supported is2TB.
Stormshield recommendsthe use of high-endurance/industrial cards or preferably, those that have a
built-in MLC flash chip developed by major brands(e.g., SanDisk, Western Digital,Innodisk, Transcend,
etc.)and with at least 32GB of memory.
** This connection in console mode requires the installation of a driver. Depending on your operating
system, you can download a driver from: http://www.ftdichip.com/Drivers/VCP.htm
SNS - PRODUCT PRESENTATION AND INSTALLATION 2019
PRESENTATION OF SN MODELS
Page 27/66 sns-en-SNrange_installation_guide-2019 - 09/2019

Table of Contents

Other manuals for Stormshield SN310

Related product manuals