EasyManua.ls Logo

Stormshield SN310 - SN900 Hard Disk Dismantling; SN900 Dismantling Procedure

Stormshield SN310
66 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SAFETY RULES
Before installing anything, carefully read and follow the safety instructions.
All models except SNi40
IMPORTANT
You must use the power adapter provided with the product.
Before plugging in any devices
l Ensure that neither your Stormshield product, the power cord nor power adapter is damaged.
l Ensure that the power supply or power adapter of your Firewall is compatible with the voltage
of your power supply network.
l When the products power cord or power adapter has a ground pin, it must be plugged into a
properly grounded electrical outlet. Ensure that the connection is reliable and that the
protective earth circuit of your installation complies with safety standards in force.
l To be able to disconnect the product, ensure that the connection to the power supply is
always easily accessible.
Before connecting to a 48VDC power supply (SN2100, SN3100 and SN6100)
Special considerations for equipment connected to a DC mains supply:
l Please follow IEC, NEC, ANSI/NFPA 70 and CEC, Part I, C22.1 for all relevant field wiring
instructions and cautions. The equipement must be installed by a qualified electrician.
l Before using the equipment, the chassis must be permanently connected to earth using
yellow/green wire rated a minimum of:
o
1.5m (16 AWG) on SN2100 and SN3100
o
3.31m (12AWG) on SN6100
l The equipment shall be connected to the DC mains supply with an approved switch or
breaker.
l Only wires with the following minimum ratings shall be used to connect the equipment to the
DC mains supply:
o
1.5m (16 AWG) on SN2100 and SN3100
o
3.31m (12AWG) on SN6100
Warranty and safety rules
Under no circumstances should you take apart a Stormshield Network appliance on your own.
Only Stormshield, which markets the Stormshield Network range, and its approved maintenance
agents are authorized to do so. A seal label protects all Stormshield Network Firewalls from being
opened.
Your warranty will be rendered null and void should you dismantle a Stormshield Network
Firewall on your own.
SNS - PRODUCT PRESENTATION AND INSTALLATION 2019
SAFETY RULES
Page 11/66 sns-en-SNrange_installation_guide-2019 - 09/2019

Table of Contents

Other manuals for Stormshield SN310

Related product manuals