General remarks
l The Status LED 2 (Run for SN6100 and SNi40 models) will blink in red (green for SN510 and
SN710 models) in the event of a major failure on the product (hardware anomaly, faulty
network interface, etc.). Contact your reseller in this case.
l During startup, shutdown or upgrading, only the LEDs Status2 and Power3 will light up.
l In High Availability mode, when the Firewall is in passive mode, the Online 1 or Run LED for
the SN6100 and SNi40 will blink (about 2 seconds off for every 1 second it is on).
l During the reset phase (defaultconfig), the Online and Status LEDs will blink (Run for SN6100
and SNi40).
l To reboot an SN160, SN160W, SN210, SN210W or SN310 appliance that is still powered up
(only the Power LED is on), you will need to unplug and plug the Firewall back into the mains
socket. It is also possible to reboot in console mode by pressing on any key as suggested.
l To reboot an SNi40 appliance that has been shut down (Power and RunLEDs off), proceed as
follows: unplug it, wait for thirty seconds, then plug the firewall back into its power supply
source.
l To reboot an SN510, SN710 or SN910 appliance that is still powered up (Power LED is off),
proceed as follows: unplug it, wait for thirty seconds, then plug the Firewall back into the
mains socket.
l You may also shut down your firewall by logging on in console mode and by typing the
following command: halt
SNS - PRODUCT PRESENTATION AND INSTALLATION 2019
INITIAL CONNECTION TO THE PRODUCT
Page 52/66 sns-en-SNrange_installation_guide-2019 - 09/2019
To Next Page
Loading...
