Stratasys Objet350 - Page 161

Objet350 User Guide 6 Operating and Maintaining the Objet350 3DPrinter
DOC-17001 Rev.G 6-30
4. Makesurethatthebuildtrayisempty,andclosetheprintercover.
ConfirmthisinthewizardscreenandclickNext.
Figure6-29WiperCleaning—step4
5. Whenthefollowingscreenappears,openthecover.
Figure6-30WiperCleaningwizardduringsteps6–10
6. Putonthecleaninggloves.
7. Usingagenerousamountofalcoholonthecleaningcloth,removeany
materialremainingonthewiperandthesurroundingarea.