Stratasys Objet350 - Page 184

Objet350 User Guide 6 Operating and Maintaining the Objet350 3DPrinter
DOC-17001 Rev.G 6-53
Theprinterheatsandemptiestheprintblock,andpreparestheprinter.
(Thisshouldtakeupto15minutes.)
Figure6-70Printerpreparationprogressscreen
8. Thefollowingscreenappearswhentheprinterisreadyforyoutoreplace
printheads.
Figure6-71Printerreadyforheadreplacement
9. Putontheprotectiveglovesandopentheprintercover.
Note:Theprinterdisconnectspowertotheheadsforyoursafety.