Stratasys Objet350 - Page 187

Objet350 User Guide 6 Operating and Maintaining the Objet350 3DPrinter
DOC-17001 Rev.G 6-56
14.Makesurethatalongwiththehead,youremovethetworubberO-ring
seals.
Figure6-76O-ringsealsontheprinthead
Important
Ifthesealsarenotremovedwiththehead,theyareprobablystucktothe
printblockhousing.Ifso,removethem.
Figure6-77MakingsuretheO-ringsarenotstucktotheprintblock