Stratasys Objet350 - Page 199

Objet350 User Guide 6 Operating and Maintaining the Objet350 3DPrinter
DOC-17001 Rev.G 6-68
IftheUVlevelmeasuredisnotacceptable,thewizardcalibratestheUVlamp
byadjustingthecurrentsuppliedtoit,andthentestsitagain.
WhenallUVtestshavefinished,theresultsaredisplayed,showingthe
conditionofthelampsaftercalibration(seeFigure6-101below).
Figure6-101ResultsandconditionofUVlampsaftercalibration
AfterexaminingtheUVcalibrationresults:
1. ClickNext.
2. RemovetheUVsensorandclosetheprintercover.Afterconfirmingthe
itemslistedinthewizardscreen,clickNext.
Figure6-102FinalUVCalibrationWizardscreen