SSeettuupp
During setup, unpack the cartons and check all items for proper operation. Confirm proper operation before you place the
product into service.
WWAARRNNIINNGG -- Always install the in-fastener shut-off system (if not using a crash-rated cot fastener) in any emergency
vehicle that will be used with this cot.
Remove all the shipping and packaging materials from the product before use.
Remove the cotter pin from the manual release bracket so you can extend the cot base frame.
The vehicle patient compartment where the product will be used must have a:
• Smooth rear edge for loading
• Level floor large enough for the folded product
• Stryker cot fastener system
• Space to install the vehicle safety hook
• In fastener shut-off module installed, if using an antler style cot fastener
NNoottee -- Loose items or debris on the vehicle patient compartment floor can interfere with the operation of the vehicle safety
hook and product fastener. Keep the vehicle patient compartment floor clear.
Unpack the battery and charger. Fully charge the battery before use.
Check the power cords, cables, and optional mounting brackets for any damage.
When necessary, modify the vehicle to fit the cot. Do not modify the cot.
EN 18 6507-009-001 Rev AB.3
To Next Page
Loading...
