Stryker Power-PRO 2 - Attaching an oxygen bottle to the oxygen bottle holder option; Attaching the base storage net option

A
B
C
D
E
F
A
B
E
D
C
F
FFiigguurree 3355 –– IIVV ppoollee rraaiisseedd ppoossiittiioonn
AAttttaacchhiinngg aann ooxxyyggeenn bboottttllee ttoo tthhee ooxxyyggeenn bboottttllee hhoollddeerr ooppttiioonn
CCAAUUTTIIOONN
• Do not load the oxygen bottle holder above the safe working load of 15 lb (6.8 kg).
• Do not use two oxygen bottle holders at the same time.
To attach an oxygen bottle to the oxygen bottle holder:
1. Place an oxygen bottle in the holder.
2. Insert the lower strap through the buckle and affix the strap onto itself to secure the oxygen bottle to the holder.
NNoottee
• Do not use the oxygen bottle holder to hold an oxygen bottle holder when the transport vehicle is in motion. Always place
the oxygen bottle holder in an appropriate storage location when the transport vehicle is in motion.
• Inspect the straps and clips for wear between use. Replace the strap if it no longer holds the oxygen bottle.
AAttttaacchhiinngg tthhee bbaassee ssttoorraaggee nneett ooppttiioonn
CCAAUUTTIIOONN
• Do not load the base storage net above the safe working load of 20 lb (9 kg).
• Always be careful when you retract the base to avoid damaging items that are stored in the base storage net.
To attach the base storage net, wrap the VVeellccrroo® straps around the base tubes.
EN 46 6507-009-001 Rev AB.3