Stryker Power-PRO 2 - Inserting the battery; Removing the battery from the product

• Gatch bolster mattress (6506-003-130) - use with the expandable patient surface (XPS) option
To attach the mattress to the cot:
1. Align the VVeellccrroo® on the back of the mattress with the VVeellccrroo® on the cot litter.
2. Attach the strap at the foot end of the mattress through the two holes in the foot end skin on the cot litter.
3. Pull the strap through the buckle and attach the VVeellccrroo® to secure the strap.
NNoottee -- The mattress is a Type BF applied part.
IInnsseerrttiinngg tthhee bbaatttteerryy
To maximize available battery power, only use batteries that have been charged within the last 48 hours.
To insert the battery:
1. Align the tabs in the battery enclosure.
2. Push the battery into the enclosure until the latch clicks into place.
RReemmoovviinngg tthhee bbaatttteerryy ffrroomm tthhee pprroodduucctt
After you discharge the battery, remove it from the product and replace it with a charged battery.
WWAARRNNIINNGG
• Do not remove the battery when the product is active.
• Do not attempt to open the battery pack for any reason, to avoid the risk of electric shock. If the battery pack case is
cracked or damaged, do not insert it into the charger. Return damaged battery packs to a service center for recycling.
• Always avoid direct contact with a wet battery or battery enclosures. Contact may cause injury to the patient or operator.
CCAAUUTTIIOONN -- Always remove the battery if you do not intend to use the product for more than 24 hours or longer.
Running the battery repeatedly, without rest periods, can increase the temperature within the cells and reduce life. For
example, lifting a heavy patient up and down several times in rapid succession can reduce the battery life.
To remove the battery from the product:
1. Press the battery release button (A) to release the battery from the product (Figure 37).
2. Slide the released battery out of the enclosure.
EN 48 6507-009-001 Rev AB.3