Stryker Power-PRO 2 - Cleaning the charger; Cleaning the battery

CClleeaanniinngg tthhee cchhaarrggeerr
WWAARRNNIINNGG
• Always wear rubber gloves, in addition to personal protective equipment, when cleaning the battery to reduce the risk of
injury.
• Always disconnect the charger from the wall outlet before cleaning to avoid the risk of electrical hazards.
• Do not spray fluid directly onto the charger.
• Do not power wash the charger.
• Do not use solvents, lubricants, or other chemicals to clean the charger unless otherwise directed.
• Do not immerse the charger in liquid or allow liquid to collect on top of the charger to avoid the risk of electric shock.
To clean the charger:
1. Disconnect the charger from the wall outlet to avoid electrical hazards during cleaning.
2. Wipe surfaces of the charger with a soft cloth dampened with a non-abrasive, disinfectant solution (see
Disinfecting the
product
).
3. Wipe with a cloth moistened with clean water to remove any cleaning chemicals or residue.
4. Dry thoroughly before you return the charger to service.
CClleeaanniinngg tthhee bbaatttteerryy
WWAARRNNIINNGG
• Always wear rubber gloves, in addition to personal protective equipment, when cleaning the battery to reduce the risk of
injury.
• Always use only non-conductive materials to wipe the battery.
• Always avoid excessive water exposure to the battery terminals.
• Do not directly handle or make contact with the battery terminals while cleaning to avoid the risk of injury.
• Do not immerse the battery in liquid or allow liquid to collect on top of the battery to avoid the risk of electric shock.
• Do not use solvents, lubricants, or other chemicals to clean the battery unless otherwise directed.
• Do not power wash the battery.
CCAAUUTTIIOONN -- Do not steam clean or ultrasonically clean the product.
To clean the battery:
1. Remove the battery from the product or charger.
2. Inspect the battery housing and terminal area for any cracks or damage.
3. Clean the battery with a disinfectant solution (see
Disinfecting the product ).
4. Rinse the battery thoroughly with clean water to remove any cleaning chemical or residue. Position the battery to avoid
water from pooling near the terminals.
5. Dry thoroughly before you insert the battery into the product or charger.
6507-009-001 Rev AB.3 59 EN