Stryker Power-PRO 2 - Page 73

RReeccoommmmeennddeedd sseeppaarraattiioonn ddiissttaanncceess bbeettwweeeenn ppoorrttaabbllee aanndd mmoobbiillee RRFF ccoommmmuunniiccaattiioonnss eeqquuiippmmeenntt aanndd PPoowweerr--
PPRROO 22
BBaanndd ((MMHHzz))
SSeerrvviiccee
MMaaxxiimmuumm ppoowweerr
((WW))
MMiinniimmuumm sseeppaarraattiioonn
ddiissttaannccee
((mm))
PPoowweerr--PPRROO 2 is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled.
The customer or the user of PPoowweerr--PPRROO 2 can help prevent electromagnetic interferences by maintaining a minimum
distance between portable and mobile RF communications equipment (transmitters), PPoowweerr--PPRROO 2, and cables, as
recommended below, according to the maximum output power of the communications equipment.
380-390 TETRA 400 1.8 0.3
430-470
GMRS 460
FRS 460
2.0 0.3
704-787
LTE band 13, 17
0.2 0.3
800-960
GSM 800/900
TETRA 800
iDEN 820
CDMA 850
LTE band 5
2.0 0.3
1,700-1,990
GSM 1800
CDMA 1900
GSM 1900
DECT
LTE band 1, 3, 4, 25
UMTS
2.0 0.3
2,400-2,570
Bluetooth
WLAN
802.11 b/g/n
RFID 2450
LTE band 7
2.0 0.3
5,100-5,800
WLAN
802.11 a/n
0.2 0.3
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in meters
(m) can be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output
power rating of the transmitter in watts (W) according to the transmitter manufacturer.
NNoottee: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and
reflection from structures, objects, and people.
6507-009-001 Rev AB.3 67 EN