Summa S class 2 series - Page 32

S CLASS™ 2 cutter User’s Manual
Setup 1-22
WARNING: Keep fingers and other body parts away from the cutting area.
There are hazardous moving parts.
8. Lower the pinch roller lever to press the media firmly against the drive sleeves. The tool
carriage will move automatically from the right to the left to sense the usable media
width.
FIG 1-22
1-22 PINCH ROLLER LEVER
NOTE:
It is not recommended to unroll the media manually from the roll. The
cutter will unroll the media automatically during the load sequence.
9. The positioning and routing of sheet material is identical to that of roll media.
10. The cutter is now ready.