S CLASS™ 2 cutter User’s Manual
Contour Cutting 3-21
3.6 Cutting through
The cutting through functionality is focussed to cut simple shapes (e.g. rectangles). It is
most used in combination with contour cutting.
An interrupted cutting line makes sure that the material remains together thanks to the
small media ‘bridges’. When the job is finished the cut pieces can be torn loose.
FIG 3-3
3-3 FLEXCUT PRINCIPLE
Some cutting software can recognize the difference between a contour line and a cut-
through line. The software first sends the data of the contour lines to the cutter and then
activates FlexCut, paneling mode and vector sorting and sends the cut-through data to the
cutter.
If the cutting software cannot do this, the user needs to send the data of the contour lines
separately, set the cutter in FlexCut mode manually and then send the cut-through data
Setting the parameters for cutting through the media:
change.
Press the arrows or use
Numpad to change the Full
pressure and press Apply to
confirm.
180 gr is a recommended
starting value for the full
(cut-through) pressure.
To Next Page
Loading...
