Summa S class 2 series - Autoload; Cut off Margin; Language; Roll-Up Media

S CLASS™ 2 cutter User’s Manual
Detailed Operation 4-11
Cut off margin:
The Cut off margin submenu is used to set or modify the distance the cutter will feed
before it will cut off the job when action ‘cut off’ is used from the software.
Press the Cut off margin and set it to the desired value.
Press to confirm or to cancel. The default value is 10mm.
Roll-up media:
The roll-up media submenu is used to choose when the cutter will start the automatic roll-
up. There are 3 possible settings. Off, after job and after AUTO-panel.
Off disables the roll-up system. After job rolls up the media after the job, regardless the
number of panels the job contains. After AUTO panel rolls up the media each time a panel is
cut. The size of the panel can be set in the Panels menu or is 100 cm when paneling is set to
off.
Press the Roll-up media button and set it to the desired value.
Press to confirm or to cancel. The default value is after AUTO-panel.
Autoload:
The Autoload option enables the user to the change the unroll-procedure of the vinyl.
When autoload is on, the cutter will automatically unroll the vinyl, when needed. When the
autoload option is set off, the operator should manually unroll enough media before
starting to cut. When autoload is set to ask, then the cutter will pause after the pinch rollers
are put down. This gives the user the time to lower the pinch roller pressure, if necessary.
The default setting is ON. Tracking is not guaranteed when autoload is set to OFF.
Press the Autoload button, then choose to activate or deactivate the autoload feature.
Press to confirm or to cancel. Autoload is activated default.
Language:
This submenu is used to set or modify the dialogue language on the touch screen. When
the machine is new, it asks the user to choose a language. If this setting was set to the
wrong language, it can be changed with this option.
The information on the touch screen can be displayed in English, French, German, Spanish,
Italian, Polish or Dutch.
Press the Language button, and then set it to the desired language.
Press to confirm or to cancel. The default language is chosen when the cutter
is switched on for the first time.
Apply
Cancel
Apply
Cancel
Apply
Cancel
Apply
Cancel
NOTE:
The recut offset should be larger than the cut-off margin if both
parameters are used in the same job. For OPOS jobs, using the cut-off command,
it is required that the recut offset is at least 30mm bigger than the cut-off
margin.
NOTE: Tracking is not guaranteed when autoload is set to OFF.