The cutter will immediately start to load the sheet. It measures the width and loads a certain
length of media, or until the end of the media is reached. The user will then be prompted to
accept the length or not.
3. Press to accept the length or go to step 4.
The cutter will now complete the loading sequence, come online and will be ready to receive
data. The loading sequence conditions the edges of the vinyl for a given length.
4. Press .
5. Press or until the required media-length appears. Then press .
The cutter will now complete the loading sequence. The cutter will come online and will be
ready. The length of the job is limited to the loaded length.
NOTE: If the rear media sensor detects the end of the media, the cutter will
complete the loading sequence without any input from the user.
To Next Page
Loading...
